Vtp not updating vlans

A switch is configured to be in only one VTP domain.

You make global VLAN configuration changes for the domain by using the Cisco IOS command-line interface (CLI), Cisco Visual Switch Manager Software, or Simple Network Management Protocol (SNMP).

VTP minimizes misconfigurations and configuration inconsistencies that can cause several problems, such as duplicate VLAN names, incorrect VLAN-type specifications, and security violations.

When integrating a Cisco Meraki Switch into a Cisco VTP-enabled domain, there are cases in which the protocol can prevent the VLANs on the Cisco Meraki switch from communicating with the rest of the network.Let’s talk about the essential part of troubleshooting VLAN and switch problems.In this post, we’ll discuss common general switch issues, VLAN related issues, and spanning-tree issues.A server is configured on VLAN 2 on the Cisco Meraki Switch.There are no devices connected on Switch 2 and no ports configured on VLAN 2 and 3 on Switch 2. After Because the Cisco Meraki Switch does not run VTP, it will act as a VTP transparent device.This information is then stored on each switch's NVRAM and any VLAN changes made to any switch must again be replicated manually on all switches.

357

Leave a Reply